Door Knock Alarm

Circuit Diagram

Knock sensor is an essential component and it is used in automobiles. This sensor is located in the minor engine block, head of the cylinder. This sensor is mainly designed to generate the voltage signal depending upon the vibrations which are occurred due to the explosion. When we observe or hear a knock or ping sound along with the noise of an engine in cars is pre-ignition. This ignition can be occurred due to the air mixture or pocket of fuel ignited in front of the flame from the flash plug. So there will be a small shock wave can be occurred around the ignition, which can increase the pressure within the cylinder. In some cases, this can damage the engine.

What is a Knock Sensor?

The knock sensor is one kind of sensor used to detect the flash knock. This flash is the state within the engine of the automobile where the fuel starts burning because of the pre-ignition, detonation, otherwise pinging.

The main function of this sensor is to monitor the ignition process inside the engine. Its indication assists the engine control to stop knocking ignition and thus guard the motor or engine control.

Working Principle

The arrangement of this sensor can be done outside of the engine block in the automobile. The main function of this is to record knocking noise within all engine operating conditions to stop engine injure.

The sensor used in the car listens to the sensations which are occurred from the engine block in the car & changes them into electrical voltage signals, which are filtered & estimated inside the control unit.



knock-sensor

The knocking signal can be allocated to a particular cylinder in the car. If knocking occurs, the explosion signal for the particular cylinder can be changed within the late direction until knocking ignition no longer takes place.

Symptoms of Faulty Knock Sensor

A faulty sensor can visible itself in different ways during fault discovery through the control unit which includes the following,

An error code can be stored

Engine power can be reduced

Fuel consumption can be increased

Warning light of the engine will be ON

Slow acceleration

Causes

A faulty sensor can be occurred due to the following reasons

Rust

The short circuit inside the engine

Damage of wiring

Wiring short circuit

Mechanical injury

Wrong mounting

How to Troubleshoot the Sensor?

Verify the sensor wiring connections and the plug whether these are connected in an exact place or not

Read out the fault code which is stored

Check the explosion end

Applications

The applications of knock sensor include the following.

These sensors are used in automotive industries

These sensors are used to control the internal ignition of engines in cars

These sensors are used to protect the machine tools

These sensors are used to detect the cavitations

Monitoring spin bearings

Thus, this is all about knock sensor. Ultimately, this sensor is very important for the vehicle proper functioning. This sensor guards the engine against inner injure. Well-known automobiles like Chevrolet & BMW offer simple alternates for it. Though, an engine of the automobile is significantly more costly than this sensor. As a result, we would suggest that any of the abovementioned signs must be taken sincerely. Here is a question for you, how to test the knock sensor?